Speedco Finned Carb Scoop dual carbs SCO1104R Base only flat

Description You are buying a flat, even mounted adjustable carb base for dual carburetors on a Speed Co scoop The centre carb bolt holes with a 6mm hole in the centre is 230mm, these can be slotted either in or out depending on your application. The 4 holes are to allow for the bowl vents to go through on either north/south or east/west carb mounting. The filter base accepts 6 3/4 inch elements and when used with the Speedco scoop up to 3 inch high elements can be used. The height of the base rings are 44mm making it for flat mounted dual carb set ups. While the cast alloy base was designed to suit the speedco scoop it can be run as a dual carb air cleaner mounting base. The Aussiespeed dual air cleaner base is adjustable in length. PLEASE NOTE THE BASE WILL NOT FIT WITH OPERATING CHOKE BUTTERFLIES ON HOLLEY OR QUICK FUEL CARBS. THIS IS DUE TO THE CARBS BEING ABLE TO BE MOUNTED NORTH SOUTH & EAST WEST. The length of the top of the scoop is 50cm The underside length is 44.5cm Front inside opening 21cm left to right Front opening height 10.5cm Rear inside height 7.5cm Front over all height outside 13.5cm Rear over all height outside 9.5cm You are purchasing a raw finish shot blasted aluminium scoop base only.